
iLive M- DANTE Option Instructions 12 AP8340 issue 4
Routing and clocking signals
iLive Route signals to the 64 Dante channels on Port B using the iLive
OUTPUTS screen Port B tab. Route signals around the Dante network
using Dante Controller. Return signals from the Dante network to the
iLive channels using the PREAMP screen Source menu. To route a
range of channels use the Remote (Port B) option in the MIXRACK /
Mixer Pref / Quick Input Source Setup screen. Remember to set the
Audio Clock Source to Internal on the first MixRack, and to Remote Port
B on all other MixRacks on the network.
GLD Route signals to the 64 Dante channels on the I/O Port using the
GLD I/O screen I/O Port Out tab. Route signals around the Dante
network using Dante Controller. Return signals from the Dante network
to the GLD channels using the PREAMP screen Source menu. To route
a range of channels use the I/O Port In tab. Remember to set the Audio
Clock Source to Internal on the first GLD, and to Slave Option Card on
other GLD consoles on the network.
Dante cards Use Dante Controller to tick ‘Preferred master’ and ‘Slave
to external wordclock’ for the Master MixRack/console card only.
For more on setting up and using the Dante network please refer to
Audinate’s user guides that come with Dante Controller and Dante
Virtual Soundcard available from www.audinate.com.
For further information on Dante software, application and recommended
networking components refer to Audinate:
www.audinate.com
This product complies with the European Electromagnetic Compatibility
directive 2004/108/EC.
NOTE: Any changes or modifications to the equipment not approved by
Allen & Heath could void the compliance of the equipment. Whilst we
believe the information in these instructions to be reliable we do not
assume responsibility for inaccuracies. We also reserve the right to make
changes in the interest of further product development.
Copyright© 2013 Allen & Heath Ltd. All rights reserved.
Comentarios a estos manuales