Allenheath DR66 USER GUIDE Manual de usuario

INSTALLER USER GUIDE Publication AP4333 Digital Audio Mix Processors DR66 & DR128

10 DR66 & DR128 Installer User Guide Front Panel 1 Ident Blocks Space is provided for writing on or adhering a label to identify

DR66 & DR128 Installer User Guide 11 6 ◄ESC Key Press and hold this key while in normal mode to view the operating software version nu

12 DR66 & DR128 Installer User Guide Rear Panel 11 POWER On/Off Switches mains power to the unit. Make sure that WinDR editing soft

DR66 & DR128 Installer User Guide 13 17 REMOTE Connections This provides opto-isolated switch closure inputs and opto-isolated output li

14 DR66 & DR128 Installer User Guide Installation This section describes how the unit should be installed into the system furniture, connection

DR66 & DR128 Installer User Guide 15 Connecting Mains Power Before starting check that the mains voltage setting on the DR unit is correctly se

16 DR66 & DR128 Installer User Guide Earthing The connection to mains earth (ground) in an audio system is important for two reasons: Safety -

DR66 & DR128 Installer User Guide 17 Configuring the Hardware Once the system is installed and plugged together the DR can be configured and the

18 DR66 & DR128 Installer User Guide Calibration Adjustments Available DR66 Parameter Adjust Factory Default Setting Mic Input Gain 1-2 Inte

DR66 & DR128 Installer User Guide 19 Labelling the Function Keys DR66 Write-on blocks are provided above each of the 8 function keys. Use pe

2 DR66 & DR128 Installer User Guide DR66 & DR128 Installer User Guide AP4333 Issue 3. Copyright © 2001 Allen & Heath Limited. All righ

20 DR66 & DR128 Installer User Guide XLR Mic/Line Input Connections You can plug in microphone or line level sources. Internal trimmers and j

DR66 & DR128 Installer User Guide 21 Calibrating Mic/Line Input Gain DR66 Adjust the internal calibration trimmer to set the input gain to matc

22 DR66 & DR128 Installer User Guide XLR Output Connections Differentially balanced, low impedance line level outputs are provided on XLR. Th

DR66 & DR128 Installer User Guide 23 Remote Switches The DR66 provides 12 opto-isolated remote switch inputs on a 25-way D-type female socket.

24 DR66 & DR128 Installer User Guide Remote Switch Examples The first shows the DR128 wired to two switches providing a remote wall plate vo

DR66 & DR128 Installer User Guide 25 Fitting the DSPx Expander Option The DSPx option card is available from Allen & Heath. It plugs into

26 DR66 & DR128 Installer User Guide Configuring the Software Once the hardware is plugged and calibrated the DR resource architecture, settings

DR66 & DR128 Installer User Guide 27 Installing the WinDR System Manager The WinDR self-extracting .exe file for PC’s running Windows® is suppl

28 DR66 & DR128 Installer User Guide Using WinDR The WinDR display has three main windows. The DR Unit Simulation Window presents a pictur

DR66 & DR128 Installer User Guide 29 Configuring Control There are several ways to control the DR unit. Once the system is configured, the insta

DR66 & DR128 Installer User Guide 3 Introduction This user guide refers to the Allen & Heath DR128 and DR66 digital mix processors loaded wit

30 DR66 & DR128 Installer User Guide Using the DR The DR is designed to be configured by the installer and used by the day-to-day operator. Th

DR66 & DR128 Installer User Guide 31 If the current configuration has had only partial patches recalled or available then the display indicates

32 DR66 & DR128 Installer User Guide Level Up Here, the function key has been assigned to increment the level of the associated input, outpu

DR66 & DR128 Installer User Guide 33 The Function LEDs The DR66 and DR128 function LEDs above the function keys may be independently assigned b

34 DR66 & DR128 Installer User Guide The Setup Keys The front panel setup keys SETUP, ◄ESC, and SET► work with the ▲ and ▼ keys to navigate and

DR66 & DR128 Installer User Guide 35 LCD Contrast Scroll to this menu item and press ►SET to enter the next screen. Press the ▲ and ▼ keys to

36 DR66 & DR128 Installer User Guide Appendix A : Earlier Version 1 Operating Software This user guide refers to the newer Version 2 operating

DR66 & DR128 Installer User Guide 37 Version 1 Menu Map (Reprinted here for reference. Not the same as Version 2) Menu Items Menu Settings

38 DR66 & DR128 Installer User Guide Version 1 – Resetting the Password (Not available in Version 2) The Front Panel Setup Menu can be passwor

DR66 & DR128 Installer User Guide 39 Appendix B : Technical Specification Headroom +12 or +16dB (according to operating level) Max Output +1

4 DR66 & DR128 Installer User Guide Important Safety Instructions WARNINGS - Read the following before proceeding: ATTENTION: RISQUE DE CHOC E

40 DR66 & DR128 Installer User Guide Appendix C : DR66 Architects Specification The unit shall be a digital mix processor with 6 analogue inpu

DR66 & DR128 Installer User Guide 41 Appendix D : DR128 Architects Specification The unit shall be a digital mix processor with 12 analogue inp

42 DR66 & DR128 Installer User Guide Installation Log Sheet SHEET : of INSTALLATION : DATE : CONFIGURATION FILE : PATCH : NOTES :

DR66 & DR128 Installer User Guide 43 DR128 Front Panel Label Template This file is provided with the Allen & Heath WinDR software. File: DR

44 DR66 & DR128 Installer User Guide Visit our Web Site: www.allen-heath.com

DR66 & DR128 Installer User Guide 5 The Mains Voltage Setting Before starting check that the mains voltage setting on the DR unit is correctly se

6 DR66 & DR128 Installer User Guide Welcome to the DR Series DR66 6 In 6 Out Digital Audio Mix Processor DR128 12 In 8 Out Digital Audio Mix

DR66 & DR128 Installer User Guide 7 Main Features DR66 DR128 • Desktop or 19” rack mount 1U 2U Removable rack

8 DR66 & DR128 Installer User Guide System Block Diagram

DR66 & DR128 Installer User Guide 9 Basic Principles Audio Inputs and Outputs The DR66 and DR128 audio mix processors accept any level of microp